POWER UNITS FOR FORK LIFT 2
POWER UNITS FOR FORK LIFT 2
General Description
High Pressure and Low Noise Gear Pump/DC Motor/Multi-functional Manifold/Valve/Tank.
Normally Closed Solenoid Operated Lowering Valve
The Lowering Speed is Adjusted by the Pressure Compensated Flow Control Valve
Hydraulic Circuit Diagram
Outline Dimension
Model Specifications
Special notes
This type of power unit works at S3 duty cycle, i.e., intermittent duty, 30 seconds on-load and 270 seconds off-load.
Clean all the hydraulic parts concerned before mounting the power unit.
Viscosity of the hydraulic oil should be 15-68 cst, which should also be clean and free of impurities. N46 hydraulic oil is recommended.
Check the oil level in the tank after the initial operation of the power unit.
Oil changing is required after the initial 100 operation hours, afterwards every 3000 hours.
Special notes
This type of power unit works at S3 duty cycle, i.e., intermittent duty, 30 seconds on-load and 270 seconds off-load.
Clean all the hydraulic parts concerned before mounting the power unit.
Viscosity of the hydraulic oil should be 15-68 cst, which should also be clean and free of impurities. N46 hydraulic oil is recommended.
Check the oil level in the tank after the initial operation of the power unit.
Oil changing is required after the initial 100 operation hours, afterwards every 3000 hours.